📏 Accurate Measurements with Measureman Glycerin Pressure Stainless-Steel Gauge: 0-35Psi Review

I used this display to replace the factory display in my Pentair PA200 filter system which had faded over time and was almost unreadable. This sensor was a direct fit (don't forget the teflon tape on the threads). I gave the same reading as my factory gauge and it's a lot easier to read. It has been installed for several months and works perfectly. The only improvement I would suggest would be an adjustable gauge to make it easier to set the pressure after cleaning the system and installing a…

Works well. I had to add a few extra turns of teflon tape to seal where it attaches to the pool filter head as it felt a little looser than the original, but I like the bright blue and red markings on the gauge. Appears to be of high quality. I just wish the lens was glass and not polycarbonate as the OEM got so dirty and yellow it was hard to read after only 10 years. Overall I'm happy with it. It seems to differ slightly from my OEM by about 3psi. I plan to test it out over the winter to…

Freshly installed on my Pentair CCRP200, it was very easy to install and this sensor is 99 times better than the cheap plastic sensor I had before. Funny story, I knew my filter needed cleaning and I knew my meter was a bit weak BUT I usually got decent readings when I tapped the meter. After installing this gauge, my pressure at high speed was 29psi while the old gauge read 19psi! So I immediately cleaned the filter and am now running around 18psi. Still a bit high, but I have yet to take an…