Header banner
Revain logoHome Page
πŸ”© 110mm-200mm aluminum metal holesaw cutter logo

πŸ”© 110mm-200mm Aluminum Metal Holesaw Cutter Review

3

Β·

Poor

Revainrating 3 out of 5Β Β 
RatingΒ 
2.8
πŸͺš Hole Saws & Accessories, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”© 110mm-200mm Aluminum Metal Holesaw Cutter
img 2 attached to πŸ”© 110mm-200mm Aluminum Metal Holesaw Cutter
img 3 attached to πŸ”© 110mm-200mm Aluminum Metal Holesaw Cutter
img 4 attached to πŸ”© 110mm-200mm Aluminum Metal Holesaw Cutter

Description of πŸ”© 110mm-200mm Aluminum Metal Holesaw Cutter

Opening iron than 5mm, the first open about 1mm deep, and then locate the drill along kerf through a hole drilled through it easier to discharge iron filings. Material: M42 high speed steel; Diameter: 200mm. Trepanning hole depth: 3-38mm. Diameter of thread: 15mm; Shank Diameter: 10mm; Blade diameter: 6 mm. Good for: aluminum, steel, casting materials, wood, plastic materials, gypsum board, stainless steel, etc.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    2
  • 1
    0

Type of review

Revainrating 2 out of 5

Not Worth The Hype in my review

This hole saw cutter was a complete waste of my time. Despite being marketed as an "Industrial and Scientific" tool, the quality was cheap and unsatisfactory. The one thing it had going for it was that it did come in two different sizes, but that wasn't enough to make up for the fact that it barely cut through the material it was designed for. Save your money and invest in a higher quality product.

Pros
  • Available in two sizes.
Cons
  • Poor Quality and Performance.

Revainrating 5 out of 5

True to size and great quality. Very sharp.

I used this to cut a hole in the countertop. This was the exact size and size I needed to place my jig to within 1/16th of an inch. It was very sharp and cut a very clean line. It was in no way flimsy or boring.

Pros
  • thread diameter: 15 mm; Shaft Diameter: 10mm; Blade diameter: 6 mm
Cons
  • I will add later

Revainrating 2 out of 5

Use of a 2-prong hole saw arbor is critical to safe use of this saw blade.

Hole saw is good, but a simple mandrel (arbor) allows a heavy hole saw to detach from the mandrel after the drill stops. The hole saw will then come loose and poke uneven holes in the nearest object or body part it falls on.

Pros
  • Depth of drill hole: 3-38mm
Cons
  • Cord shorter than other cutting tools