🔧 Enhance Stability and Performance with Mevotech MS251057 Control Arm and Ball Joint Combo! Review

This is solid steel as opposed to the hollow uca stamped steel the factory uses. All pros and no cons so far. A good product.

I would give this product 5 stars but it has a hole in the oil can and won't stay lubricated. I have attached photos so you can see. Replacement would be correct to do with the seller. Otherwise it fits perfectly and is much more stable than stock!

The product appeared to be durable. Was on my 09 Ram 1500 for about a month. For those who don't know, post-install alignment is required. If installed correctly, there should be no installation issues. You'll need to squeeze the coil's shock absorber to straighten it. If using a jack, I recommend using a jack under the wheel hub to re-tension the shock. I used a hydraulic lift and used a jack to tighten mine.

I ordered these for my 2009 Ram 1500 along with some other Mevotech parts. My ball joints came loose along with the tie rods. The quality of these wishbones and ball joints is amazing. An added benefit of these control arms is that the bushing is already installed, as is the ball joint. I was very surprised when I removed the factory levers. They were nothing more than bent stamped steel and very flexible. These Mevotech levers are solid steel and don't flex at all. After leveling the front end

This fits my 2011 Dodge Crewcab 4.7L 2WD very well. I brought two of these in August 2018 and wore them in December 2018. Hey easy to install it took a workshop as the alignment mechanics was done in about 30 minutes. February 2019 Right bearing failed. Went to the AutoZone, got two replacement bearings and had them installed on Wednesday February 13, 2019. Went back to the same shop to get another mechanic, he couldn't align the right side at all. I uploaded my order to my Revain account and…