Header banner
Revain logoHome Page
🪚 morse mhsa10c circular saw blade attachment diameter logo

🪚 Morse MHSA10C Circular Saw Blade Attachment Diameter Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🪚 Hole Saws & Accessories, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(1)
img 1 attached to 🪚 Morse MHSA10C Circular Saw Blade Attachment Diameter

Description of 🪚 Morse MHSA10C Circular Saw Blade Attachment Diameter

Patent Pending tooth set design optimized to remove material faster. Attached arbor and pilot drill included. New side slot increased leverage for faster, easier slug removal. New exterior red coating reduces side wall friction for efficient cutting. Heavy duty .050 side wall for greater stability.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

sizing inaccuracies. Low low quality.

Should a 5/8" hole saw drill a 5/8" hole? Not with this article! The pilot drill is not concentric with the outer saw. If you look closely at the photo you can see that the center pilot drill is 3/32 inch off center. So he drills a 13/16 hole in hardwood - too big for a 5/8 dowel. No trial and error. I got it right, I had to buy another hole saw from a different manufacturer to solve this problem.

Pros
  • Hands free
Cons
  • Very expensive

Revainrating 5 out of 5

Ideal tool for removing 1/2 " round nuts on Jeep Wrangler with 2 piece nut.

Just removed the center drill and ran it over the wheel stud with the problem until the wheel came off the Hub loosened.A very small portion of the aluminum wheel was lost causing the wheel bore to become immobile leaving very little visible damage to the wheel.Tried a nut remover at first but the wheel stud was too badly damaged to save the wheel stud anyway, very bad satisfied with the end result.Remember to constantly lubricate the bolt about every 15 seconds of drilling.

Pros
  • Happy for now
Cons
  • I'll write back later