🪑 Optimized Search: Modway Calibrate Gray Mesh Drafting - Reception Desk Chair - Tall Office Chair Review

Measure the table height. I liked the chair but it's too small for my table. I work standing at my desk and I like to sit because of the long hours. It's tall, but not as tall as other barstool-height stools. The back brace is great with lots of adjustments.

Packaging was destroyed on delivery. Luckily all the items stayed in the box. This chair is simple at best. A few adjustable elements are good. The bottom pillow is thin and not the most comfortable. The rear is just fine. The wheels roll a little. I won't lie, I was very disappointed.

I bought this chair for a standing desk so the chair would be at the same height so I didn't have to raise or lower the desk when coming out from the standing to sitting. The problem is that the chair lowers itself. I got a replacement gas damper and it's still lower. Now I have to buy another chair so it was a waste of money.

I bought this 1 year ago and have only had problems with it - seat is not tight on cylinder - backup ring will not stay where you tighten it. Any pressure and it slides down instantly. The overall seat height is only 27 inches when nobody is seated. The seat recline button is not lockable so it is ALWAYS in the forward position and you always feel like you are slipping off the chair. Very disappointed with the poor quality product. Do not recommend buying.

I love the many settings this chair has! Seat depth and fit are good. The height range is also nice and hard to find (although dropping it about an inch lower for use as a standard chair would be even better). Just two criticisms: the seat sits too far forward, requiring the legs to be bent quite far back to rest on the toe ring. On most drafting chairs, the seat is reasonably centered front to back over the leg ring. With this one, the front protrudes a few centimeters and the back protrudes a

After owning this chair for 2 months I feel I need to update my review. My original review remains below. After 2 months of home use, the chair started to creak. everything is loud When sitting down, getting up, shifting weight, the chair made a terrible creaking of the backrest. Also, the pressurized piston holding the base of the chair would accidentally lose all pressure and I would sink about a foot. Sometimes it resets when I get up, sometimes it stays for a while. The toe ring also…

I know most office furniture is mass produced, but this chair reigns supreme. Inside was a mass of materials filled with very cheap, crumbly styrofoam (the worst kind of styrofoam). When I unpacked everything I found there were no instructions. Footrest, this is a round hollow metal tube in which you can hear a small particle rolling (very annoying). The plastic that the rollers are attached to has fairly badly cut ends as you can see in one of my photos. Inexpensive manufacturing process! The…