Header banner
Revain logoHome Page
mofeez flywheel locking duramax engine logo

Mofeez Flywheel Locking Duramax Engine Review

3

·

Poor

Revainrating 3 out of 5  
Rating 
2.8
🚗 Transmission & Drive Train, 🛠️ Replacement Parts

View on AmazonView on ЯM

Media

(4)
img 1 attached to Mofeez Flywheel Locking Duramax Engine
img 2 attached to Mofeez Flywheel Locking Duramax Engine
img 3 attached to Mofeez Flywheel Locking Duramax Engine
img 4 attached to Mofeez Flywheel Locking Duramax Engine

Description of Mofeez Flywheel Locking Duramax Engine

Save time--- Locking the flywheel at the transmission instead of having to remove the starter for water pump replacement. Toothed pieces only---Work with Duramax 2500 / 3500 pickups .Remove metal spring-loaded inspection plate on the bottom of the transmission. Tool should slide into opening toward engine with the top of the tool engaging the teeth of the flywheel. Toothed pieces with screws--- Work with Duramax 4500 / 5500 trucks.Remove the rubber inspection cap on the bottom of the transmission.Insert the tool at the front of the opening to engage the flywheel and hand tighten bolt to hold tool in place. Forged 36mm socket---Use on the balancer bolt.Use with a 3/4" square drive wrench. Quality tool ---Made of CRV steel with durability, flywheel locking tool is anti-rust and corrosion-resistant, will last a long time.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Misleading and Ineffective Flywheel Kit

After trying this automotive product, I was left extremely disappointed. Not only did it not fit my vehicle, but the kit itself was poorly made and offered no significant improvement for my transmission. The installation process was also a huge hassle. One positive note is that the instructions were clear. However, it's not worth the money for an unreliable and useless product.

Pros
  • Clear instructions
Cons
  • Misleading, poor quality, ineffective

Revainrating 5 out of 5

works as stated in parts section

The best way to remove the balancer on DuraMax. Makes you hate the engineer who designed the water pump for the Harmonic Balancer a little less. Just make sure you have a long breaker extension when you start this job.

Pros
  • . Transmission parts only. Work with Duramax 2500/3500 pickups. Remove the metal spring loaded inspection plate on the underside of the gearbox. The tool should be inserted into the hole toward the engine with the top of the tool engaging the flywheel teeth.
Cons
  • I have no negative feelings about it, everything is fine.

Revainrating 4 out of 5

Works great but not perfect

This tool works great and saves a lot of time without having to remove the starter. However, I had to file my teeth quite a bit to get it in place. If I had known that from the start, it wouldn't have lasted long. But I tried for a long time to level it, tried to hammer it in. Finally noticed marks on the end of the flywheel teeth, just didn't fit. A small incline, he slid right into place

Pros
  • Saves time --- Locking the flywheel on the transmission instead of removing the starter to replace the water pump.
Cons
  • Very expensive