🚗 Precise Steering Control with MOOG K8700 Pitman Arm Review

Moog products are the best suspension parts money can buy. Probably better than factory. This part was way cheaper than anywhere else I could find.

Great replacement for my 1999 high mileage 4WD F150. The stout is made in the USA. The bearing arm was very difficult to remove. I had to use a cutting wheel. This part will support the whole car.

I replaced the upper control arms; The lower ball joints and inner tie rod end in addition to that pitman arm on the front of my 1998 F150 are all Moog parts and all fit exactly as advertised with no issues. I was pleasantly surprised to find "Made in the USA" written on each of them. After the new parts were installed and the alignment was complete, I actually noticed a tighter and smoother ride. On this Pitman arm you should use one of the quality pullers - I screwed up the cheap one and…

I ordered this for my expedition and it arrived late (not the fault of the seller or Amazon. It was due to Covid-19 and Post. (Land Transporter) _) It turned out that the problem was not in the connecting rod, but in the defective output shaft of the steering gear. It was installed together with a new gearbox. It was 100 times better than what it said on it. It fits snugly and feels meaty. The fat cap is thick and fits well, unlike Chinese ones with thin or no paper dust caps. how long does it…

This part fits and works perfectly. The biggest problem was removing the old traction. I rented a puller from a local auto parts store and spent hours trying to get the old lever off the steering box. The draw bolt featured a round head at the end, which prevented the use of a socket. I tried it with a 12 inch adjustable wrench. I was then unable to remove the lever and I was unable to remove the tool from the lever and spent part of two days trying to find a way to remove the puller from the…