🔧 Precision Caster/Camber Adjusting Kit: Moog K100128 - Ultimate Alignment Solution Review

Used for 2007 Toyota FJ Cruiser. They have grease fittings to keep them from rusting internally like standard Toyota cams do. Installation was easy, but it goes without saying that you will need a professional to get the front end alignment angles correct.

Not the best option for replacing factory bolts. Had to buy real ones from dealer after they didn't work when installing new levers. It is very annoying when unsuitable parts are under the car.

Try. It was quite difficult for me to replace them as I'm not a mechanic and have never done anything that would require replacing the roller pins. It took me a while to level the front end enough to take it to a leveling shop. I think the instructions could be a bit clearer. So far I haven't had any problems with them. I'm glad I got them. It's probably better to ask the store to install these

This is junk. Spend extra money to get factory screws. The crescent shaped cutout on the washers will round out as you try to adjust the alignment. Now, thanks to moog, I have to buy all the new parts from Toyota, swap them out and realign them. By the way, all bushings are new, everything is lubricated and does not stick. I'm a mechanic and believe me I wouldn't sell them to my worst enemy.

I had to use a saw to cut off my old stuck bolts and didn't want to do it again. I oil them with every oil change. I bought a lifetime alignment contract from Firestone and the techs love them so much they trade their cars in for them. I installed them on my 2007 Toyota 4Runner which tend to jam. I've had no issues with them being misaligned or snapped (I adjusted them to my car's specs). Hope they last as long as the car!

I bought these to replace the stuck lower arm bolts in my 2003 Toyota 4Runner SR5 4WD. The picture is deceptive but the parts that came included all the correct parts including different sized bolts and cam adjusters. Lubricated hardware is a must as other Toyota parts have stuck and I had to cut them out. It only took a few days but everything is installed well and once the alignment was complete there were no problems. hope they hold up. Not updating this review means they are still working…