Moog K3166 Control Arm Bushing Review

Nice Hub. It's a belly up the sleeve, so naturally installing it is a pain. Would buy them again in 15 years when they wear out.

As always, Moog does not disappoint! Excellent bushings! They are not officially listed by Moog as front top link bushings on Jeep Grand Cherokee WJ 99-04, but they fit great!

I have a Grand Cherokee Laredo 01 Jeep. i replaced all my wishbones and they still had some play so i am looking at these moog axle hubs and they fit, the hardest part was pulling the old ones off a total of 2.5 hours r and r the next hard part was installing the levers, but in total it took 2.5 hours, i also bought mopar sockets just in case but used moog products

Bought 2 of these kits. One was brand new (below in the first picture, right pair in the second) but the other arrived covered in road dirt, it is NOT a Moog brand and had 'Made in Mexico' printed on the rubber. The Moog box says Made in India. I have sent these fakes back and am waiting for the third pair. The score is updated when the third pair matches the first. ****UPDATE****The third set is brand new in the box, just like the first. Write it off as some idiot returning a used item and not

Revain car is wrong. They fit perfectly on the 2002 Jeep Grand Cherokee Limited (WJ) 4x2. Front upper wishbone bushing (axle side). They are properly tapered for easy installation. You still have to press them in to get a rental ball joint kit from Advanced Auto or similar. I didn't even remove the spring, I removed the wheel. When operating the control handle, only do so on one side at a time as the bolt holes can be difficult to align. I'm lucky. I also greased them well.

I installed this on a 2002 Grand Cherokee with a Dana 30. They fit great. I had to hire a ball joint press to press them into the axle. comes in a set of two, i bought new levers for the top. they work and fit as expected. I don't think I would have done anything else. I know the MOOG website says they won't fit, they are a good replacement for the stock part. I had the same concerns as everyone else about buying them as the car is not on the list. no problem with installation.

I have a '99 Jeep WJ Grand Cherokee 4.0 and didn't know where to get the bushings that go into the front of the Dana axle for the upper and lower fit wishbones. Even though they say they don't fit the Cherokee 99-04 WJ, they certainly fit and are right by MOOG. The person who installed it had no issues with it and said it's a steal for the price as MOOG expects durability too. So if you are looking for a 99-04 WJ axle side replacement front control arm bushing, this is the correct hole size…

First, Revain "Does this part fit your car?" wrong for Jeep Grand Cherokee (WJ) 1999-2004 These are (K3166) the correct front axle top link bushings. Each pack contains two bushings, so you will need two boxes to make all four tops. They are the same front/back and left/right. The body side can be done with a shop press or a hand press as the arm will come out when the screw is loosened. The side axle bushings are more difficult as they are pressed into the axle and not the arm. A hand press…