🔌 MOTOALL 2 Pin Ignition Coil Connector Case: Perfect Fit for Toyota 1JZ, 2JZ, Lexus SC300, Mazda RX7, and More! Review

Figured out how to disassemble with a small pick. Replaced all 3 on my 4runner without having to connect to existing cables. 30 minutes work. The quality is very good.

They are of poor quality. Plastic looks like cheap ABS and properly assembled. You can see how the cork on the bottle was not put together properly and the plastic was cracked.

I used it to replace faulty ignition coil connectors. I didn't use the cable that came with it as the wires in the engine harness were fine. Just remove the cable and the installation on the car works fine so far, I installed it last month

I was able to use these to replace the VVT valve plug covers on my Volvo XC90 B8444s engine which was cracked and broken internally due to heat damage. I removed the wires and pins from the new connectors and inserted the factory wires and pins into the bearings.

I don't often write reviews but these things are phenomenal. They detached easily from the pigtails, went right into my factory harness terminals, and connected just as well as they came from the factory. And the price is next to nothing. Even if they only last until the next fork change, they're worth it.