🔧 100pcs MOTOALL Honda Acura Nylon Front Fender Liner Bumper Shield Fastener Clips - 8mm Hole, 91512-SX0-003 Review

A third of the clips in the bag are broken. As you can see in the photo, the part that contains the male part is missing a leg. Do not buy. Garbage.

The OEM has a 90% failure rate (10 years later) and is around $2 each at the dealer. They worked and it costs pennies more than the OEM so they break I don't care.

Far from OEM Honda/Acura clip quality. They don't even look alike. I had a hard time getting the clamp to any of the three places I needed and when I tried to remove it it came out. You can forget to take them out if you can get them in. Definitely try a different kind of customer service.

These things are super cheap compared to Honda clips and the quality of the product matches. Burr forming is not well controlled and if you don't tear it apart before installation, you will break the clips during installation. However, once installed they work just as well! On the other hand, if you are exposed to heat or dirt, consider them disposable when attempting to remove them.

The clamp head is slightly raised compared to the 8mm OEM fender panel clamps but it is not noticeable unless you look into the wheel arch and even inside Most people will never know or realize it. The holding power seems strong. They also fit the plastic hood at the base of the windshield; except for the 2 far terminals which are 10mm terminals, not 8mm terminals. So 100 clips for the price of 3 or 4 OEM Honda clips was a steal.

I work in a Honda body shop so I am familiar with these clips. Others say they are easy to install but not very easy to remove without breaking. I think they haven't worked on a lot of Hondas. If you make Honda fender liners, plan on replacing every Honda clip. They are fragile and break almost every time. The OE clips are better quality and you don't have to assemble them that way, but they will both break when removed. That's why you buy them in the first place