🔩 Rust-Free Stainless Steel Mounting Bracket for 9000-36000BTU Condenser Ductless Mini Split Air Conditioner/Heat Pump Systems - 2 Pari Review

Very good product. The instructions on the side of the box are in Chinese, but it's a bracket. a rocket science degree is not required. The kit also included standoffs; requires a 3/8" masonry bit. Again, the edges are very sharp so use care when handling. The condenser pictured weighs 115 pounds.

This is a good and durable bracket for mini split heat pumps. The only problem is the transmission of noise into the house. Because it's a solid mount with no rubber bumpers (other than the "feet" of the unit), low frequency sounds will transmit through my 2x6 wall. If you have the possibility to mount the outdoor unit on a base, this is the best way to avoid noise.

Not really big enough to put the air conditioner far enough away from the wall. The 1 ton compressor block I have requires 12 inches of clearance from the wall and that works out to just over 6 inches. Everything works, but the airflow should be somewhat restricted. This mount is VERY durable, either made of stainless steel or coated in some way. It doesn't look like it will rust at all.

No instructions but they are not needed. All devices included. The stainless steel brackets for the mini convectors have been in use for a month now and show no signs of rust. Very secure mount for my 12000 BTU device. I was installing on a hollow log wall and decided to use molybdenum bolts instead of the split bolts that came with it, but split bolts would probably work just as well. Note: the small brackets above are what I added to support the freon lines, they are not included in the…

Quick review: Do not buy this if you plan on using it with a MrCool DIY mini split. Unity (and 360 #) I doubt it. Even though the parts are stainless steel, it doesn't even look like 14 gauge. It's "100% Chinese" meaning everything on the box was in Chinese and no instructions as far as I could tell. It contained 4 screws with a concrete sleeve; However, I think they were metric. Also, I can't imagine mounting this device with less than 4 screws per bracket. The supplied screws for attaching…