🔌 120Pcs Multicolored Breadboard Dupont Jumper Wires - ALLUS J7011 3in1 Ribbon Cables Kit for Arduino and Raspberry Pi, Male to Male (M/M), Female to Female (F/F), Male to Female (M/F) Review

Jumper kit overview: Very poor quality. I've hardly used them and the pins are bent and the little sheaths come loose. Wow. DISSATISFIED. Edited to include an image and say "Oh come on dude".

Happy with the purchase. The connectors fit onto the breadboard as expected. These wires are great for quick Raspberry Pi projects to connect sensors and other electronics.

That's great! I like the colors, the pin seat is ok. may be a little loose when you connect them together. Otherwise they are excellent, they are well understood when necessary, soldered without problems, the quality is good.

I've repurchased these a few times and they're great for prototyping but I find the wire inside is a little thin making soldering into a circuit can be a little tricky. Challenging (but doable). I will buy them again.

it was a bit of a shock. Sometimes I relocate DuPont wires to other pins. The socket ends of these wires hang from a pin and often fall off after initial insertion. However, the first time holds tight. Otherwise a great product.

Pack contains 120 pieces with 3 different connection types (male-male, female-male and female-male). I needed a male/female connection above all, but I bought the pack because others come in handy sometimes, the pack had 2 sets of male and female and none of the male and female. Good quality overall and probably just an oversight in the packaging but it put me off production. I would still buy from them again.

someday. I did some breadboard wiring and some random wires around the house that worked, but I replaced that mess with a few of these and things are a lot cleaner. I'll probably have to get more, I've used about half of it. Note that there are three different types in this pack, which is great, but if you want them all to be the same type (female to female, which is what I use most of the time) you may not have enough. But I like the flexibility of having a male to female connector for…

I used this on an RC car I built with the following components. x1: 5 Sets 9V Battery Clips with 2.1mm x 5.5mm DC Male Connector for Arduino from Corpcox1: 2 Pcs SMAKN Fr4 Ky-023 Joystick Breakout Module Sensor Shield for Arduino Uno/Arduino UNO R3/Arduino 2560/ Arduino 2560 Rx1: Qunqi 2Packs L298N Motor Drive Controller Board Module Dual H-bridge DC stepper Motor for Arduinox1: Dupont Jumper Wires Colorful Breadboard - ALLUS J7011 120pcs 3-in-1 Male to Male Ribbon Cable Kit (M/M ), Female to…