🔧 NANPU Filter Regulator Lubricator with NPT Fittings Review

Installed twice with shutdown. I had to throw away many parts after the first leak. It leaks where the 1" connections are made. It has bad threads on the inlet and outlet. First I sealed it with thread tape, it was leaking so I disassembled the air system around it, cleaned all surfaces and used pipe ointment .So that thing doesn't leak It shouldn't be overpriced If you want your air system to be pressurized don't get this.

I never run my tools above 90psi. Never had this problem in stores with a legal water/oil separator. So DO NOT BUY, IT'S GARBAGE. i will return it If it hasn't already ruined my pneumatic tools due to lack of water separation. And it tends to leak from the 1st tank with a spring-loaded piston (water separator, I'm not wrong, maybe it's true 😇)

I didn't filter much water, if any. Luckily I had a built-in spray gun filter, otherwise I wouldn't have been able to paint at all. This filter let enough water through to completely saturate the built-in filter, and eventually some of the water ended up in my paintwork. The O-ring can also get stuck in the gap between the drain and the plastic, causing a leak. Another problem is the car oiler. It works fine when you open it, but it doesn't close completely and jumps a bit when you turn it off.