🔌 Electric Power Running Board Motor for Left Driver Side by NewYall Review

Perfect fit. I did it myself, an hour and a half. I had to swap the orange and yellow wires! But 2 cuts and snapshots back together and works great.

Not bad to install. The easiest way is to completely remove the footrest. They thought that they sent the wrong page, it is necessary to add instructions on how to reverse the engine. Otherwise it's a good product for the money.

5 Star Rating. even thought the power input and output switched to the ground wires. The running board went down when I closed the door. and above when open. Cut the wires and switch (after trying to change the pins of the connector. Don't do this. The connector is cheap and it's impossible to put the contacts back in). works great now. And a lot cheaper than the hundreds of dollars the parts dealer was asking.

Incorrect connection wires. It was the right port, but it wasn't working as it should. Open the door, close, close the door that was opened. The plug has a total of 5 wires. I found that 2 power wires (orange wire and yellow wire) were on the wrong side of the plug. I gave 2 stars because I'm disappointed that I had to cut the wires, but it works fine. Well, let's see how long it lasts.

The direction of these types of motors is controlled by magnets in the housing. If the motor runs in reverse DO NOT CUT THE WIRES, simply loosen the three small case screws and rotate the case one set of screws. If that doesn't work, turn the case over again. The direction of your motor changes. It's not the best motor - it doesn't seem to work well even with my cleaned and oiled hinges whose bushings are in good condition - but it's cheap and it works. If you want perfect and fast work, choose