🔧 NGK 22060 Oxygen Sensor: A Reliable Solution for Enhanced Engine Performance Review

The price of this part was reasonable compared to other manufacturers of the same product. I had to install it in my app because of the location. The CHECK ENGINE light has not come on for several months. As far as I can tell, I'm fine.

This is a great and correct part for front O2 sensors. Don't buy O2 sensors in the back and use them in the front (use these in the front). The rear sensors don't get hot which is a must, this one gets hot like it should. Installed on 03 max 1 with no problems. Great item for a good price.

Went to local dealer, they sold me low flow (o2) sensors when I asked for high flow (broad range) sensors. Said the old part number was no longer made. The machine worked terribly so that's exactly what I did. some research. This is the same part that Ford sells minus the green sleeve. Two of these are in my 2008 GT Mustang and it runs like a raped monkey. Couldn't be happier!

I have used them on a Mustang GT and for the most part they were identical to Motorcraft. They have longer wires and the connector body itself fits snugly, but it doesn't have the alignment ribs of the original. This does not cause problems when using them. What I like most about them is that the wires are longer. On the Mustang the two front oxygen sensor plugs were a nightmare so luckily I swapped them and just cut them off to remove the exhaust pipe and make it easier to replace. Because the