🚦 Nilight 8 Gang Aluminum Rocker Switch Panel: Blue Backlit Toggle Dash, Pre-Wired 5 Pin ON/Off Rocker Switch for Car, Marine, Boat, RV - 2 Years Warranty Review

Had to rewire to 12 gauge when powering up the system a bit but it was perfect. It was my personal choice not to burn the wires. Very cool design and easy to use.

I redesigned the center console in my 71 MGB/GT. In this setup I removed three of the eight switches to make room for my ammeter. Fits without additional cutting. Nice simple backlit switches.

Feels solid I don't have any pictures of this hooked up in my truck but I've tested it and it works great. This is a metal mouse bezel with great textured switches, I recommend it!

This illuminated 8-way switch is pre-assembled and ready to install. No complicated circuit diagrams. I specifically labeled my switches according to my specific needs and in the order I wanted them. Installation was easy. I placed spade connectors on the incoming wires and connected them. The blue lights are amazing! Good product.

I have 2 complaints about this product. First, used connectors are very difficult to remove even with the recommended method. (I had to modify the schematic to accommodate the dash light circuit.) The second is purely personal preference. I think the manufacturer's label on the panel spoils its aesthetics. Reminds me of Tesla's "Signs" song. The plate has excellent thickness and holds the switches securely in place. Didn't measure the thickness. but it is thicker than 0.0625 (1/16) inch. Note…

good. Just take a look. This switch set comes in a box with wires pre-wired to the terminals. The wiring is so tight that removing the connectors will also remove some of the terminals from the back of the switch, rendering it unusable. Confusing one of them, I found a cleaner way to remove the terminals. This product is a perfect example of Chinese reverse engineering, made so cheaply that I believe it will last a very short time given very little use. I originally bought these to replace the…