🛠️ OCGIG Titanium Deburring Tools with Countersink Chamfer Review

Undoubtedly, these are the best countersinks for Wood, Finishing. DO NOT ATTEMPT TO USE THIS ON METALS. I find that more aggressive looking countersinks are better suited for use with metal. So far I've used one size for my purposes, but there are three more in the kit that you may need. They are small and large enough for small to medium sized applications. The sinks come out clean and round with no dirt or burrs when used with a power drill. Using a hand drill will give you the same result…

I'm installing T-Track on my workbench. I set up each section to have as many mounting holes as possible, leaving the area at the ends of the T-rail where they meet with a low support area. I would like to add additional mounting holes but these need to be countersunk so the screw heads will be flush. After some research, they seemed to be the best for getting a clean bevel. When they arrived I was disappointed that the smallest of them wouldn't fit in the T track to make the blind hole. I was…

Update I used again later the next day. Countersink MFD for saw table. The third largest would only go 1/2 way to the lip before just spinning and burning my table. He didn't stop or any other excuse, he just didn't cut any deeper. Now I understand that this is garbage. They're not even worth the few dollars they paid for. I am very disappointed in bits other than a small one. The little one did a wonderful job, but the rest is junk time. I'm sending it back for a refund and planning to buy…