Review on 🛠️ OCGIG Titanium Deburring Tools with Countersink Chamfer by Jeff Aulia

I'm installing T-Track on my workbench. I set up each section to have as many mounting holes as possible, leaving the area at the ends of the T-rail where they meet with a low support area. I would like to add additional mounting holes but these need to be countersunk so the screw heads will be flush. After some research, they seemed to be the best for getting a clean bevel. When they arrived I was disappointed that the smallest of them wouldn't fit in the T track to make the blind hole. I was planning on sending them back but wanted to see how well they work. I took a piece of T track, drilled a hole in the ground and then used this countersink. I was surprised! It was a VERY clean cut! As you can see in the photo he cut the aluminum in one continuous strip. I keep these beats. Actually I just bought a set for my brother. I can't comment on how well they work with harder metals (yet), but they're perfect for aluminum.