🔌 Enhanced Performance: OCR 2 54Mm Breakaway Connector Arduino for Efficient Connections Review

I used them to break off the stepper motor driver. I used both male for motor contacts and female for logic contacts. The males worked perfectly! women were pain. The design needs to be adjusted to create a notch between the pins. Similar to males helping with snipping or slicing. When I cut them I used sharp wire cutters. I had to sacrifice a pen after the cut. Then, after cutting, I used an Xacto knife to clean up the edges. The edges are also not that easy to align. Otherwise these pins work

As with other suppliers, the socket strips cannot be "torn off". For example, to get a 10-pin power strip, you would have to somehow cut through the 11th strip and file or sand the excess to get a clean 10-pin socket. A lot of extra work IMO. I think a little more attention to shape would have made it possible to make narrow plastic channels between the pins and make "peeling" a lot easier. The males aren't much of a problem as you can use wire cutters to effectively separate them. Everything…

This is a good set of plugs, pins and plugs. This applies to circuit boards, not so much to cable ends, although you can use them to improvise a cable connector. The only problem with them is that socket outlets with sockets require one of the sockets to be crushed and sanded down to reduce its size, but that's not the product's fault, it's just the way it works and all similar products are same. Path. They're cheap enough that I don't care, but I've seen people complain about them. I've used…