🚗 Upgrade and Personalize Your Car with EZ Lip PRO 2-Inch Lip Spoiler, the Original Universal Fit - Black Review

I have added before and after photos to this review. At the same time, I have no complaints about ezlip. This is the quickest, easiest and cheapest way to give your car a more aggressive look. This isn't the first time I've used ezlip, I've had it on my black GXP and it's been amazing, everyone kept asking "where have you been?" "get that front lip" which is also the bumper before the lip protects you get from smashing parking barriers and curbs, it even comes in different flavors, check it…

Give away some cars I own. I will be using it on my Se-r B13 and will be ordering a regular Ez lip for my Swift Sport Zc33 as it's a little less thick than the Pro I just ordered here. It is very easy to install. I will measure and make a few cuts before installing for a perfect fit. There are many videos on YouTube about how to install this product and no one will be able to install it. Take the best ideas from every installation video you watch and do it yourself!

Follow Installation Instructions. Except that after pressing the tape open I decided to drill 6 holes and rivet them in so the edge would never fall off! Too much feedback on what's going on for me. First, my car is pretty low, but I just used a Phillips with a drill and put in rivets. I don't have a jack and I couldn't use the car ramps so all I could do was stick my drill under the front bumper, I couldn't even mount the drill with the drill bits. Phillips head only as it was shorter.

After lowering my Subaru I wanted the front end to 'look' very low off the ground and ez lip pro did just that! When I hit the floor the foam just wraps around the floor and doesn't make a big noise. Really easy to apply but you really only have one shot because it sucks. I used self tapping screws to drill through the bumper so it never came loose. I wouldn't recommend that for your new BMW. Definitely recommend this product to my friends. Everyone asks and I absolutely tell them to get the…

So if any of you are in the same boat as me, your car has no service. Finding a front lip for my car was like pulling teeth. Like many of you, I turned my head when I saw that the lip was just double sided tape. But since I lowered the car, I realized that I should at least try. Let me tell you that the glue is there forever. Overall the lip was very easy to put on, the glue held so well that I made the mistake of placing the lip too high around one of the corners and couldn't get it off to fix

Don't normally get reviews but wanted to help with this product, have mixed feelings about this product. Just installed last weekend, weather 20 degrees (there were probably 40 in the garage) no problem. Now I've rinsed under the bumper with isopropyl alcohol probably 4 or 5 times to make sure it dries very well. I then used a hair dryer to heat the part of the bumper I wanted to start with. Before applying to a warm bumper, I made sure to warm up the glue well. If you do this through the…