🔧 Genuine Replacement Antenna Ornament 86392-0C040 for 07-13 Toyota Tundra - Repair Kit for AM/FM Antennas & Stereo Receiver Base Review

I sold my truck but I noticed that the base of the antenna was worn out. So I bought one of yours and it fit perfectly. Looks like when you first bought the truck.

I really liked how fast they delivered! The only reason I gave it 4 stars is because it stated that instructions would be included but there were no instructions at all? It's easy enough to do without, but this note should be removed from the list.

Easy to install but be patient. Must sit in two layers of rubber protection to fit. I recommend spraying or rubbing some lube on the back of the jewelry before attempting to install it in the fender.

that fitted perfectly. It took a little time to install, but the trick is to grease the base of the antenna and the rubber case. In order for the base to fit snugly against the fender, you will need to remove the inner fender liner and press on the base of the antenna.

The car wash destroyed my original, always removed the antenna. I've never had a broken antenna at a car wash, I don't know why these guys insist on taking it off before driving through. Anyway I got it and the stump, no problems since.

It was a bit tricky getting it back on perfectly and it kept pushing the female end of the antenna back deeper into the truck as I put the part in place and was able to ' Don't pull the threads tight. I ended up slipping the antenna rod through the plastic, screwing the antenna directly onto the threads and pressing the plastic in place.

This is a hard plastic replacement for the factory rubber antenna. I don't recommend it as it took a lot of cutting and repositioning to get this product to work. The hard plastic doesn't fit the space, and I had to take the hard plastic off—and take off—and take off—until I could fit it. Buy a quality rubber - I will - it conforms to the contours and keeps water out (IMHO). This is my main problem with the Frankenstein product installed on my Tundra. I will replace soon!

The plastic this device is made of is too hard. You can't notch the tail around the fender hole. I ordered a standard OEM unit for $5.00 more with Prime and it took less than a minute to install. I spent over an hour and a half installing this with no success. I couldn't make the seat block all the way around. I may have gotten a bad one, but after feeling the difference in the OEM plastic I don't think so.