Header banner
Revain logoHome Page
πŸ”₯ otoolworld graphite ingot mold 1/2-1 ounce - ideal for silver and gold melting, casting, refining logo

πŸ”₯ OTOOLWORLD Graphite Ingot Mold 1/2-1 Ounce - Ideal for Silver and Gold Melting, Casting, Refining Review

3

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.3
πŸ—Ώ Sculpture Supplies, 🧢 Crafting

View on AmazonView on Π―M

Media

(2)
img 1 attached to πŸ”₯ OTOOLWORLD Graphite Ingot Mold 1/2-1 Ounce - Ideal for Silver and Gold Melting, Casting, Refining
img 2 attached to πŸ”₯ OTOOLWORLD Graphite Ingot Mold 1/2-1 Ounce - Ideal for Silver and Gold Melting, Casting, Refining

Description of πŸ”₯ OTOOLWORLD Graphite Ingot Mold 1/2-1 Ounce - Ideal for Silver and Gold Melting, Casting, Refining

Outside dimensions: 1.65" x 2.25" x .45" (4.2 x 5.7 x 1.15cm). For Silver Bar: 1/2 Troy Ounce (15.6g) Cavity Inner: 0.175" Depth x 0.339" x 1.575" at bottom (0.45x0.86x4cm). 1 Troy Ounce (31.1g) Cavity Inner: 0.175" Depth x 0.63" x 1.693" at bottom (0.45x1.6x4.3cm). Also fit for GOLD Bar 28.3g and 56.6g.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    2
  • 1
    0

Type of review

Revainrating 2 out of 5

Disappointing Quality for Casting Needs

As a result of my tests, I determined that this graphite product from OTOOLWORLD did not perform well in terms of melting and refining. While it was able to handle basic crafting needs, it fell short when it came to more complex tasks. The biggest drawback was the poor quality of the graphite itself, which resulted in irregularities in the finished product. Unfortunately, this product did not meet my expectations and I cannot recommend it for serious casting work.

Pros
  • Affordable
Cons
  • Poor Quality

Revainrating 3 out of 5

good but small

Product worked well but was much smaller than expected! If you were more familiar with the process you might be able to know, but I had no idea how to delve into it.

Pros
  • crafts and sewing
Cons
  • expensive

Revainrating 2 out of 5

Not impressed

For ingots in further processing, this is normal. However, you are half. You can see deep circular drill marks that are short and thin making them ideal for a jewelry press but not for ingot casting.

Pros
  • Casting and casting
Cons
  • Questionable purchase for the elderly