🔌 Oudtinx Electric Abrasive Accessories for Polishing Review

Just spent the weekend sanding quarter inch detailed steel sections and they worked fantastic! I burned about 3 beats but the job is done and I have plenty for my next project. Added to my mantra "always have the right tool for the job".

Will not tighten in my 1/8 collet on Milwaukee M12 rotary tool. Shaft is too small. The 1/8 collet requires a 3.2mm shank. It's 2.8mm. One of my two Dremel 1/8 collets is tightening. The stones I used are far inferior to the quality stones. Too soft, they wear out too quickly and lose their abrasiveness. More Chinese junk!

I like to have a large selection. stones of decent quality; no broke. They did a good job of grinding the hard steel molds to the desired configuration. Much better than anything I had on hand as it has come with a variety of previous purchases. Metal particles tend to clog any of these oxide grains, but to a lesser extent than some of the others I've used. I used a worn grinding stone to remove some of the blockages.