Enhanced Visibility: Partsam 4PCS 4x6 LED Headlight Conversion Kit for Kenworth KW 900/Peterbilt 379 Review

Surprisingly bright and fairly easy to install. Much better than the old headlights on my Impala 77. Very clear at night and they look great!

Nice and bright. Installed on my 86 High Beam Mustang Side Bend Ground Strap. From the low beam side, you need to change the location of the contacts in the factory power and ground connectors. never mind

I was skeptical about these lights because they were so cheap but they are surprisingly easy to install, I had to rearrange a few wires on the plugs in my 83 k20 but that was to be expected you very much!

They will NOT fit the Land Cruiser FJ62 directly as Revain claims. Neither does the adapter the carrier says I need for my car. I only had to spend $250 to have my mechanic build his own jig to make them work. I would NOT recommend them.

Headlights were easy to fit on a 1986 C10. I had to buy braids to make the light work. I used a pigtail to splice the wires. Much cheaper to repair than the whole wiring harness. The headlights give me more visibility than the original headlights. People drift off the road or need to adjust their mirrors when driving on the freeway. This is included without glare. I would buy again and recommend.

So far they look good but I had to buy an adapter to make them work with my 2008 Chevy C5500. They are definitely brighter and appear to be extending much further. The only problem we have is that they are LED, car driving daytime running lights don't light up. I assume it's because the truck uses half the energy when driving during the day with the low beams closed? May be? I think the LED can't read that low voltage. Does anyone have a solution to this problem other than turning on the low…

*** how do I connect the video to my Instagram @iron_ox_squarebody *** Ok so I put them in my 87 suburb. Very easy to install, you just have to change the wires in the connectors to the headlights, for which you only need a small flathead screwdriver. They are SUPER BRIGHT, literally different from regular headlights day or night. I bought them 6 months ago and during my hunting season they've been through a lot of dirt roads and all the LEDs are still working and I've never had a problem. If…

This goes straight to my 87 K5. Fits in the holder when you take it all apart. The vent cap behind the light can be removed if you want a slightly tighter fit, but it's not necessary. 2 Compress it fully to secure. Easy wiring. I connected high, low and ground for low beam and just high and ground for high beam. Thus, the low beam works normally, and the high beam turns on together with the high beam. Be prepared to rip your car's braids apart to reattach the wiring if necessary. The lights are

So imagine an '86 Camaro with Original Equipment halogens, a yellow glow with limescale on the glass. Now imagine you're outside on a typical sunny day, but wait, it's not the sun, it's your car. These lights made me cry because I was driving in thick fog at night. I never knew how much I needed them until I was driving back roads with all those twists and turns. disadvantage disadvantage. The lamps do what they are supposed to, BUT. If you own a 3rd generation Camaro, you either need to be…