Partsam Smoke Trailer Waterproof Identification Review

Light is good but not bright enough to be seen 50 feet away when flashing. Wiring coolers are old words. When I get the light, red is high, black is low, white is earth, that's all the words on these lights.

Came quick and easy to install but there isn't much of a difference between running light and brake light. I ordered two sets, one set stopped flashing after ten minutes and there were no mounting screws in the kit

They work great, just check the wire colors for the right connection. The black was hot and the white was crushed. Red was for the brakes and the signal. I have used 2 on my chevrolet twice for lower high gates. You can buy 6 for the price of a GM replacement. My truck is black so they go well together.

I put six of them on my tablet and some lights are already starting to go out, the difference in brightness with running light 2, regardless of whether it's stopping or turning, is almost immeasurable. Basically I just have to turn people off because they can't see my turn signal flashing.

I bought this a few months ago but only installed it two weeks ago. I installed them on a headache shelf for my truck. They worked great and looked good for about a week and a half. I then towed my fifth wheel trailer and when I plugged in my tow lights most of the LEDs stopped working. Now only two LEDs in the middle of each lamp will work. I was impressed when I first put them on, now I'm disappointed that they have already stopped working.

A little thinner, darker and cheaper than I expected. Although to be honest the description was accurate. I have two real problems: the back isn't flush and the protrusion on the back doesn't match the whole for the previous light source, and the light source can't be positioned to work. Next you need to drill and cut new screw holes to install the light. In addition, the bar is so narrow that it does not completely cover the hole in the frame or the markings of the original lamp. The light…