Header banner
Revain logoHome Page
petg rod bestfilament 1.75 mm, 1 kg, yellow logo

PETG rod BestFilament 1.75 mm, 1 kg, yellow Review

1

·

Poor

Revainrating 2 out of 5  
Rating 
2.0
Industrial and Scientific, 🏭 Additive Manufacturing Products, 🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(6)
img 1 attached to PETG rod BestFilament 1.75 mm, 1 kg, yellow
img 2 attached to PETG rod BestFilament 1.75 mm, 1 kg, yellow
img 3 attached to PETG rod BestFilament 1.75 mm, 1 kg, yellow
img 4 attached to PETG rod BestFilament 1.75 mm, 1 kg, yellow

Description of PETG rod BestFilament 1.75 mm, 1 kg, yellow

One of the most durable consumables for 3D printing, PETG is available in a variety of colors! Advantages of PETG Bestfilament: * Very strong filament; * Adhesion of layers is unprecedented; * Parts made from this material are durable; analogues; *Suitable for most FDM printers. Related materials for 3D printing: film, glue, varnish, dryer. PETG is a wear-resistant copolyester (combination). PET stands for polyethylene terephthalate and the G indicates that it has been modified with glycol for greater durability. Durable material, exceptionally strong and odorless when printed. The use of an automated quality control line guarantees a deviation of the bar diameter within one coil of no more than 0.02 mm. Recommended print settings for PETG Bestfilament: Extruder: 220-245 degrees. Platform: 60 degrees. Advice from Bestfilament: If you have problems removing the finished model from the table, we recommend that you cool the product to the extreme: take it out into the snow, put it in the freezer. To improve the adhesion of plastic to the platform coating, we recommend using a film, glue, varnish. If the plastic is wet, we recommend using a dryer.

Reviews

Global ratings 1
  • 5
    0
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Bad! I am not satisfied with the quality of the product.

to the table (with adhesive tape or glass) sticks badly, small elements do not stick at all. If the element is round, then during sadness it shrinks and becomes smaller in diameter or does not stick at all. it bakes badly, the temperature is 240, and the fan had to be turned off. there is a lot of debris due to ductility. As a result, about 80% went into the trash, but what didn’t go away is still terrible and with defects.

Pros
  • The fact that half a kilogram is not so pitiful, because the plastic disappointed
Cons
  • Poor adhesion, strong ductility - threads remain, layers do not sinter properly, geometry is broken during cooling.