Enhanced PIC 102D 158F Connection Pressure Internals: A Robust Solution for Improved Performance Review

This gauge is perfect for bleeding brake pressure I made from a cheap $10 garden sprayer. Used a "Legines brass fitting, 1/8 NPT female bulkhead anchor" to attach to the canister after drilling a 5/8" hole. Works fine, no leaks. I could use my air compressor instead of a hand pump to get it up to 15psi to bleed/flush the brakes.

What a disappointment given the good reviews. Like at least one other reviewer, I have used this sensor in a liquid transfer tool that was converted from a garden sprayer to a car sprayer. So it was screwed into the plastic. what has been carefully done. When threading, the needle left its resting position relative to the pin at point "0" and rotated about 320 degrees, where it stayed. for some time. After about a month and after about 10 uses, the needle is now opposite the pin at 0, but on…

So everything is relative. For the price I paid it worked well, some might give a negative review because they had higher expectations. Here's the thing, it works fine, just don't leave it in a vacuum for a week, mine is after all. suddenly, suddenly Read an even lower vacuum reading because there is more vacuum than free space. Instead of -30, it looks more like -35. I can still use it to see that there is no vacuum leak, just not an accurate gauge. Normally the gauge should operate at a…