Header banner
Revain logoHome Page
🚜 polaris upper front brushguard for off-road vehicles logo

🚜 Polaris Upper Front Brushguard for Off-Road Vehicles Review

4

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.5
🚘 Bumpers & Bumper Accessories, πŸš— Exterior Car Accessories

View on AmazonView on Π―M

Media

(4)
img 1 attached to 🚜 Polaris Upper Front Brushguard for Off-Road Vehicles
img 2 attached to 🚜 Polaris Upper Front Brushguard for Off-Road Vehicles
img 3 attached to 🚜 Polaris Upper Front Brushguard for Off-Road Vehicles
img 4 attached to 🚜 Polaris Upper Front Brushguard for Off-Road Vehicles

Description of 🚜 Polaris Upper Front Brushguard for Off-Road Vehicles

See product description below for vehicle fitment or to verify fitment for your specific vehicle, please contact us, and provide us with your VIN that can be found on your vehicle or your insurance card. Full coverage design protects against unforeseen objects. Provides additional protection beyond stock bumper. Does not impede headlights, winch, or plow attachment. Scratch-resistant, black powder-coated.

Reviews

Global ratings 4
  • 5
    0
  • 4
    1
  • 3
    1
  • 2
    1
  • 1
    1

Type of review

Revainrating 4 out of 5

Doesn't quite match the crossbar.

I received this on Saturday. I opened it yesterday for installation and it was damaged on one side. Looks like someone dropped it and scratched it. Also, the crossbar doesn't fit

Pros
  • complete set
Cons
  • security

Revainrating 2 out of 5

A good brush strip feels strong, but the fasteners suck

Factory fasteners are disappointing, 4) Torn hex bolts in head. I found the hex head screws and replaced them. The ones holding the cross brace, I don't know why they don't get away with all 6?

Pros
  • Not just useful for its intended purpose
Cons
  • So-so

Revainrating 1 out of 5

Beautifully fitting after installation and repainting!

Didn't match front bumper color or texture, took a long time to "persuade" to put all the crappy screws in place. In the end, the hardware was replaced with real screws on site. I wasn't impressed with a part called Polaris that didn't fit or fit better.

Pros
  • Great selection
Cons
  • Nothing

Revainrating 3 out of 5

CHINESE MARK FOR POLARIS SOLD BY POLARIS

I TAKEN TWO HOURS to bolt the left and right 3 piece piece to the wrongly drilled bumper. Throw away the equipment. You need to install the left/right pipe into the stock front bumper, which is pretty easy. Once fully installed, the pre-drilled holes will be half an inch off alignment. Someone else said they used a coma, but in this case you would have to bend something in the bumper or brush guard. Now you're trying to put the cross on badly and it's two inches overhanging because it was too…

Pros
  • Large selection
Cons
  • I'm concerned about