🚪 A-Premium Tailgate Rear Hatch Lift Supports Struts for Ford Explorer 2006-2010, Sport Utility, 2-Piece Set Review

Although this is the correct length the fittings at the end of the cylinder are straight and not slightly angled. Secure attachment to the vehicle is not possible in this configuration. 2007 Explorers tailgate

I installed a new tailgate lifter 5 days ago and was surprised. When I opened the back door today, one elevator was broken and the other almost a brake. Any proposal ?. Super bad quality! $75 goes in the trash.

Not even close. Too bad I didn't try to install them right away because now I'm stuck with parts that don't even remotely fit or fit into the 2008 explorer, they were "guaranteed to fit". 😡

sunroof lift cylinders are NOT a direct replacement. The mounting bushing on the end of the cylinder was not angled like the original, making installation difficult and putting stress on the cylinder assembly. I will return them if I can't swap the sockets from the old ones.

Cheap nameless Chinese junk, no vehicle standards stamped, no markings. Will not fit all 2006-2010 Ford Explorers at all due to the lack of an OEM corner connector. Ordered an OEM from a Ford parts dealer.

They had to replace tailgate lift rods for my '09 Explorer. They arrived quickly and appeared to be of good quality. However, they were too long to fit. They installed quickly, but I was disappointed to find the back door didn't close with them. They were too long. So go back.

Tailgate pillars do not fit 2008 Ford Explorer! I see many people saying the same thing about their 2006-2010 Explorers. Why are they still sold as FIT for Explorer but they don't work? They are about an inch longer. Now I have to reset and send back the old ones. Very discouraging.