Professional milling machine (machine) for manicure and pedicure Sunkin Electrical, diamond coating (white) Review

The device (machine) for manicure and pedicure Sunkin Electrical is designed to care for nails of hands and feet. The maximum speed of turns per minute - 20000, is regulated by the round handle on the forward panel. It can work in normal and reverse modes. A built-in fuse is provided to prevent overheating. The handle holder of the device is made of shock-resistant plastic, inside there is a metal clip for a cutter. Package contents: Power supply, micromotor handle, set of diamond and disposable cutters (6 nozzles with diamond coating for processing the edge of the nail, grinding, fine grinding, removing the cuticle, removing calluses and rough skin, cleaning under the nails, correcting artificial nails and finishing polishing) , stand for a pen. Specifications: Rated voltage - 100-240 Watts, 50/60 Hz. Power - 20 W. Torque: 1 N/cm. Reverse: yes. Nozzle retainer: Crimp - rigid fastening with a clamping ring. Rated speed: 20000 rpm. Unit size: 13 X 8.5 X 6 cm. Handle length: 14 cm. Operating instructions: 1. Place the machine on a dry surface. 2. Make sure the wires, plug, socket are in good condition. 3. Insert the desired cutter. Make sure the cutter is well fixed. 4. Before plugging in the appliance, make sure that the switch is in the “OFF” mode to avoid injury caused by sudden start of operation. 5. Set the speed switch to "0". 6. Connect the machine to the network. 7. Turn on the machine using the power button. and also turn on the button on the handle. 8. Set the desired rotation speed (+ -). Change the speed on the instrument panel smoothly. Avoid sudden movements. 9. At the end of the work, move the speed control to 0 - the rotation of the cutter will stop. 10. Turn off the appliance using the button and also the button on the handle. 11. Disconnect the appliance from the mains. Wait until the cutter has come to a complete stop before putting the handle down. Precautions: 1. It is undesirable to turn on the router without a nozzle. 2. Do not turn on the instrument until the handle collet is secured. 3. Do not open the collet during operation. 4. Avoid getting water into the device and its installation on wet surfaces.