🚗 Universal Black Rubber Rear Bumper Protector Guard - Scratch-Resistant Trunk Door Sill Protector for Car Exterior, 35.8Inch, Easy D.I.Y - Greatream Car Accessories Review

This product is made of rubber which makes it easy to install. In terms of durability only time will tell but it fits and conforms to the shape of the bumper to offer a factory look.

I got this for the 2018 Equinox and if you take your time it will be fine. Not sure how long it will last, but it's been a month, several car washes and showers, and it's still there. They give you lots of double sided tape to attach it very well.

I was a bit worried about the length of the double sided tape but it was actually enough and the rubber strip bent easily to fit my 2018 LEAF. The instructions for use were pretty straightforward and we ended up with a great looking bumper that is as good if not better than the factory version. Thumbs up for this product.

Why can't they use double sided tape like everyone else? The product is very thin, I do not expect long-term use! It's easy to put a gumball supporter on the mat, but it takes an act of Congress to get rid of the red tape without removing the gumball. I finally put it in the freezer for a while and solved it without ripping off the goo! There are better products that are easier to use! I got what I paid for!

Seems to work as expected although I've only had it on my bumper for 5 days. It was easy to install and the materials seem to match the product. The tape seems pretty minimal for the product but has worked well so far. It's a bit shorter than I expected (probably I measured it wrong before ordering) and the curve doesn't perfectly match the curve of the bumper (Toyota Prius v 2015), but I managed to fit it to the bumper in a reasonable way . Time will tell if the adhesion is sufficient.

Great for Toyota Yaris rear latch. Super happy with the end result, it's not perfect but for $13 and some spare change it's an absolute bargain! enough double sided tape to make three lines and both ends. I cut it about 1/4 inch from each end so it doesn't go up the curve of the bumper if you are unfamiliar with Toyota Yaris, those cars are pretty small. I had to clean up the edges (like they used a dull blade for the final cut, but scissors and a steady hand can't do anything). tape the edges…

I really needed 4 inches of height to cover all the dents and scratches on my boat trailer. Since they only sell 3" heights, I had to get creative. I really wanted the one with the red sports logo, but I also bought two all-black rear bumper covers. I cut one in two to extend the other two guards. (See photo). I used larger tape to hold the pieces together and used roller tape for the edges and everything in between. There isn't enough tape in the kit to cover everything. I had to use others…