Enhance Towing Stability with PullRite 2911 Short Mounting Feet Set Review

Note: Leave blank until the coupler is on the rails in the truck. the holes are elongated to allow the rails to be moved. After the coupler is seated on the rails, tighten all the screws.

Perfect addition to my PullRite clutch. When using the Reese adapter kit to install the PullRite on a Ford fifth wheel, the hitch was raised too high. These mounting feet lower the hitch by the same amount and help lower the nose of the trailer for better traction.

Our new truck is higher than our old one. The front of our RV was too high. The 1.5 inch lowering of our hitch was enough to raise the front of the RV a bit higher. I had no trouble installing them, but a kick would have made the job quicker and easier.

They do what they're made for, they lower your Pullrite ISR by 1.5 inches and you might not think that's a lot, but it really looks like it when you plug it in, too if you measure beforehand. -1 star because of the price. Contacted PullRite and quoted me less and it was even more than the price here on Amazon with additional postage and also slower shipping. The quality is also not as good as the original set of brackets. This one welds a lot less over a much smaller contact area, and the piece