🔌 Uniden DFR Series Radar Detector Hardwire Power Cord: RJ11 Mirror Wire Mount - 3005201U Review

I chose to connect to the rear view mirror for my installation as I had previously done with ease on the Infiniti G37 I previously had . This wire is of high quality and I have no doubts about its durability. However, for the wiring harness of my particular mirror in the Kia Stinger GT, neither set of pins were thin enough to cut into. I ended up having to take the thinner pins that came with the wire and use wire cutters to trim the ends to a very sharp and narrow end and then sand down the…

After some feedback that the cables don't fit many cars, I doubted my installation would be any different. However, the pins on this wire fit perfectly into my 2015 Chevy Silverado mirror harness and do not chafe. black wire into the black wire connector (out of the eight colored wires on the connector) and then connected my old radar detector (Valentine One) as a sacrificial lamb. It turned on immediately with no problems, so I plugged in my new Uniden R3, also with no problems. Very happy…

I can't believe detector manufacturers still include coiled power cords that plug into the cigarette lighter socket. 21st century. This gets the job done and even comes with adapter pins so you have two different sizes depending on which port you plug into. For my VW EOS application this was more than adequate but I couldn't connect the actual connector to the rain sensor, the two piece plastic cover never fitted again so I plugged it into the headliner and connected to the power supply. /floor

I chose to connect to the rearview mirror for my installation as I've done it before on an Infiniti G37 I with no problems used to own. This wire is of high quality and I have no doubts about its durability. However, for the wiring harness of my particular mirror in the Kia Stinger GT, neither set of pins was thin enough to connect to. I ended up having to take the thinner pins that came with the wire and use wire cutters to trim the ends to a very sharp and narrow end and then sand down the…

. However, the pins on this wire fit perfectly into my 2015 Chevy Silverado mirror harness and do not chafe. black wire into the black wire connector (out of the eight colored wires on the connector) and then connected my old radar detector (Valentine One) as a sacrificial lamb. It turned on immediately with no problems, so I plugged in my new Uniden R3, also with no problems. Very happy with this switch power option rather than running a 10ft RJ11 cord around the windshield and behind the…