🔦 Headlight Adjuster Angel Eyes Xenon Halogen Pair for BMW E39 2000-2003 528 530 540 M5 - RegulatorFix Review

I have seen many videos about repairing my flashlights without opening them. I knew I needed these parts to replace the broken parts that were wobbling around in my headlights. This is exactly what I needed for my E39, 2001 530 with HID headlights. With GREAT patience managed to replace broken adjusters without heating or removing the plastic lenses. I inserted the controls into the desired position through the holes for the lights. IT CAN BE DONE. They fit perfectly and the price was great. No

El producto vino a solucionar el inconveniente de que las luces de mi carro no se podían ajustar. Encajan perfectamente, Es un poco complicado instalarlas, pero una vez que ha puesto la primera la segunda luz se hase más fácil. No hase falta despegar los lentes, siempre y cuando tengas dedos delgados. Algo importante es saber la posición de los repuestos, i die en mi caso estaban hechos polvo ui don't estaban en su lugar. Si los suyos aún están en su lugar, tome photos para saber la posición en

Ordered kits for a 2001 e39 525i. Initial observations showed that there was little difference between sets, with one arm sagging slightly lower than the other. This wasn't a problem though, as it worked fine in the headlights when installed. I didn't want to bake the headlight like many people recommend so I installed them by messing around on the back of the headlight where the high and low beam connectors were connected. It took 4 hours of work just to feel the rails that the controls are…

This kit is suitable for 2001-2003 E39 headlights. I have a 2001 525i. This job took me over 6 hours. The long adjuster that goes next to the low beam was relatively easy, if you use a piece of tape as shown in the YouTube video the square adapter is much more difficult and it took me the full 3 hours to figure out what caused it was not getting it right because the piece was too big to fit where it should. It's about 1mm too much and 1mm too high so I filed to bring the broken piece together…

In general the quality is satisfactory. The regulator sits too tightly in the mount, which makes installation a little difficult. It is made of very hard plastic and the adjustment screw is very tight. And that's a pretty serious problem because on the other side of the adjustment screw is a plastic nut that is molded onto the adjustment screw. The nut is used to turn the adjustment screw inside the regulator. However, since the adjusting screw is too tight in the adjusting screw, the old…