📱 (8-Pack) RinoGear Screen Protector for Samsung Galaxy Watch Active 2 (44mm) - Full Coverage Clear Film with Case Friendly Design Review

As the glass of the watch is slightly beveled at the edges, this screen protector is too big. Oversize causes a small protrusion of the protective film that catches on clothing and eventually peels off completely. This small protrusion also creates a gathering area for dust and dirt. It would be nice if the screen protector could fit on the actual flat part of the display. I've added some pictures of the overhang which is the problem. I'll keep them to save time, but I definitely wouldn't…

What can I say when you need a screen protector (or 8!) for your watch that doesn't stick up too high to avoid it clinging to objects that are so looking close to invisible as far as you can assume the one that is easy to install is right for you. The screen protector is very clear, fits the 44mm Galaxy Watch Active 2 very well, fits very neatly and easily, and you get eight of these screen protectors! For the price you can't go wrong in my opinion. The only thing to really note is that you get

Easy to use. Glued without bubbles and edges with slight pressure after drying. Watch the application video first as there are no written instructions. There is no noticeable reduction in touchscreen sensitivity. Let me just say that on most screens there were visible air bubbles on the sheet due to dust particles I suspect. I specifically picked one with air bubbles to see if they go away or if I need to reset them. There were no bubbles or air pockets. I am satisfied with the product. I can't

Easy to install. Link to installation video included. The protector is applied using a liquid solution, which may or may not be included in the kit. If it's not included, just mix some dish soap and water. Then you simply need to 1) clean the watch 2) remove any dust from the screen 3) soak your fingers and the screen protector in the solution 4) press the screen protector against the screen (the adhesive side touches the screen) 5) center the screen protector the screen in wet condition 6)…

I had absolutely no idea what I was getting myself into. The initial setup requires soapy water and turning the watch off for about 20-30 minutes. Then you need to let it dry/cure overnight. However, it takes over 48 hours to fully dry and cure all the blisters and I don't even know how good this protection is lol. I'll see if I can remember to update this with how it actually works. To update! So I was bored and gave it a try. This is not a 48 hour process. This is a night process. YouTube…

1st star: very easy assembly 2nd star: clear; no image distortion 3rd star: protects the watch somewhat; something is better than nothing. My Dislikes: (1) Does NOT cover the entire jar. It only covers the part that shows something. The bezel used as a rotating bezel is not fully closed. (2) Water stains everywhere! Water stains live on every glass surface, we cannot control that, but water stains on this screen protector are not easy to remove. They appear to be glued to the tread; You can't…