🔧 Rivco 1-Inch Black Engine Guard Clamps | CLMP1BK Review

To fix them you have to hang on the key a lot. If they slip, they will ruin the road poles. If you tighten them enough to avoid slipping, they will damage the road bars.

This is bullshit, I need 3/8" mounting hole clamps for Rivco road pegs with (you guessed it) 3/8" mounting screw. Where in the universe is a 1/2 inch hole equal to a 3/8 inch hole? Don't get me started with scratches. See photo. Pathetic!

finish: good quality size: reasonable performance: insufficient price: reasonable The smooth inside of the yoke does not hold the pins in place. Minimal foot pressure on the pins will cause the mount to move.

The goods are fine. Sturdy, pretty easy to install, looks pretty good. However, it is not possible to tighten enough to prevent the pin/clip from slipping once installed on the motor housings, even if you carefully place your feet on the pins. I ended up drilling a zip tie into the motor housing and inserting a screw (see photo) which seems to be working fine at the moment. Even if it's annoying. Maybe someone smarter than me will know a better way.

I have ordered them to fit highway pegs to Canyon cages on the FJR1300. Everything I needed turned up (Sunday delivery) - BUT the install stopped because one of the 3 halves of the clamp was 1" and the other half of the same clamp was 1.25". Whiskey Tango Foxtrot. Above. When I requested a Revain return I went to back order and it said it was out of stock for a few weeks. I had to use Kuryakyn 1002 1 "Magnum" quick clamps (which only come in chrome. I have to paint them black).