🔌 ROCKRIX True 4 Gauge Complete AMP Wiring Kit: Boost Amplifier Installation, Enhance Speaker Connections & Power Up Your Car Audio System Review

Comes with lots of cables for Tacoma double cab. True gauge wire and very flexible. At the point marked on the power cable where a fuse holder can be added, I would suggest cutting off the middle and adding heat shrink tubing to the cap. Fuse holder, not my favorite, took a minute to figure out, unscrew the end and it all pops out

This harness is a really good quality item. Boss kits are cheap quality (bought a few years ago, cables and connectors are very cheap) and Rockford kits are good but overpriced. This kit is great quality, really good quality and great price.

Great starter wiring kit, not solid copper but does the job. Many items included for multiple connections, great price. Take your time with the installation and you'll be fine. Used with Crunch amp, JVC head unit, Cerwin Vega 6x9 and Skar subwoofer. No noise from these cables.

This item is a 4 gauge kit but comes with a 10 gauge fuse. In fact, it is COMPLETELY impossible to plug a wire into a fuse port. When I say impossible, it won't happen without stripping the wire, so it's basically useless. So I can't even use the kit. If you try to use this kit, your car will catch fire if the fuses are not connected properly.

Bought an 8 gauge wire set. If you have any doubts about choosing this kit, just do it. This kit had pretty much everything I needed to set up my amp. Comes with a 60 amp fuse. My amp recommended 40 amps, which could easily be replaced. Wire #8 is very flexible, thin core approx. Since my battery is in the trunk, there were a lot of wires. All connector ends were included.

Excellent cable set with everything you need for the installation and the amplifier. I love that it comes with a wire harness already installed on the first 3 feet of the power cord. It looks clean under the hood. Choose a longer size if you plan to put it in the trunk. I bought a 20ft kit and stuck the amp under the passenger seat. I just finished installing it so not sure about durability but it works so I'm happy.

Not yet installed but appears to be a legal 4 gauge wire size. I didn't smash the wire with a caliper, it reads a little more than it should. It's not just very thick insulation like other kits. It's copper-coated aluminum so won't deliver performance like 100% copper wire, but at least it's thick. It's also a lot cheaper than buying a copper kit and my amp doesn't draw that much anyway so it works for me.

I was a bit hesitant to order this set at first, mainly because I wasn't sure about the quality. But I'm glad I made the purchase. The thickness of the wire's outer jacket is more than adequate for most tight pinch points. The power cord is long enough to run the entire length of my machine. The wire is really 8 gauge and you don't get a small conductor and a quarter inch of insulation. The only thing I would like is that the bottom is a little longer than a meter. But I think that's the…