🏔️ Enhance Off-Road Performance with Rubicon Express Steel Degree Shim Review

Works great on my Blazer 02 1 ton axle replacement, set drive shaft at right angle for U-joints. steel and hard work! I will buy again!

Do not use aluminum washers as they will tear when the U-bolts are tightened and will dissolve over time due to corrosion from road salt. These steel spacers are well made.

Arrived as a pair and already coated. They work as expected. Use them on my 79 CJ7 to tilt the rear gear to the transfer case as I replaced the driveshaft with a constant velocity joint.

Just what was needed to fix the camber lifting problem on my '92 Jeep Wrangler. Dart issue fixed! Factory reset the camber. No more shaking the steering wheel!

. The washer is exactly what I'm looking for to fix the gear angle on my raised k5 blazer. Trouble is, I only have one puck. What should I do with a puck? Now I have to order another one because we all know that there are 2 leaf springs on each axle.

These seals are excellent. First-class workmanship, perfect contact surface for centering pin. And steel! I replaced the 4 degree aluminum shims that came with the lift kit and installed these 8 degree shims as part of my SYE upgrade. Used on Jeep YJ rear axle.

Ideal for correcting the walking angle. However, the hole was too small and I had to ream it to 3/8 inch. Strong metal and chewed my bits! It would be nice if this kit included grade 8 bolts/nuts for use as a centering pin. at Home Depot for $3.50 to complete my project and they worked great.