🕒 Runleader Digital Hour Meter: Ideal for Lawn Mower Generator, Motorcycle, Farm Tractor, Marine, Compressor, ATV, Outboards, Chainsaw & More! Review

I needed an hour meter for my Zero Turn mower so I can plan maintenance and repairs. Fits perfectly into the existing slot on the mower frame. Easy to chain.

Looks great. Works well. Fits very tight. I just sanded the ends a little to match. Buy 5 of these for a Toro brand. FYI: Toro only powers the hour meter when it is in the seat.

Like. Installed on my Toro Timecutter MyRide (model #75759). I liked it so much I bought another one for my golf cart. I am the happy owner of 2 such measuring devices. Pull the trigger and get it.

Instead of buying an overpriced Toro hour meter, I bought this one. The facility was great. I had to remove the spade connectors from the black Toro wire adapter to install it on the gauge. This is easily done with a small screwdriver to loosen the wires. After disconnecting the wires, it's easy to connect the meter.

This hour meter works well but is not as easy to install as what Toro offers. However, for less than half the cost, it's well worth the extra effort to install. If you can crimp a pair of spade terminals at all, it will be easy. Since the hour meter has a slightly different configuration than a Toro plug, all you have to do is a few jumpers and you're done.

I replaced an analog hour meter I bought from Revain that no longer worked (second of this model) with this meter. I connected this meter to the battery and let it run until it reached what I assumed was the hours on my zero turn lawnmower. Then I installed it on my mower. I had to enlarge the hole it went in a bit, but the installation was just connecting the wires. So far this has worked. I've mowed twice since installing it. The time will show.

I ordered 4 different hour meters from runleader before I was able to find the right one for my application. It's a simple device that always shows the clock, no buttons to fail, advertised as waterproof (not tested), simple 2 pin digging, flat front and back as it doesn't protrude too far from the mounting plate. This is exactly the gauge I wanted, simple yet accurate. Installed on Yong Heng 4500psi Compressor. Will be updated if there are any issues in the future.

Let me first say that I have not set the watch at the time of review and will update should my review require changes. I installed this on my Exmark Quest E series. The hour meter wires were glued to the wiring harness and I cut a hole where it was marked. I had to shave the plastic a bit to make it fit, but that's okay. Simply connected after I disconnected the cables from their bracket on the mower. He sat down in the seat, turned the key, and blinked to indicate he was registering. It's…