🚦 Enhance Safety: RUXIFEY Sequential Switchback Mirror Reflector LED Turn Signal Compatible with 2009-2014 Ford F150 - Smoked Lens Review

Great way to get rid of that ugly piece of orange plastic on the Ford F-150 09-14 mirrors. The fit was tight, look closely at the headlights, there is a right side and a left side, two blades went to dr. lateral and wide single blade suitable for pass. Side. If you can get smaller turn signals on the inside of the mirror from the same company, you don't have to splice wires, so it's completely plug and play.

These were purchased with a matching set of turn signals and plugged straight into the turn signal kit. very much plug and play with these units. It took about 30 minutes to make both mirrors. The hardest thing is getting down from the mirror itself. Next, use a Torx T20 screwdriver to unscrew the four screws securing the back of the mirror housing. It's a bit snug so it took a bit of pressure to fully engage but overall it's a great product. My only objection is that maybe a slightly longer…

Just received and installed today. The passenger side landing was a little tight so I had to cut out the mirror cover a little then it fitted very snugly. The lights were NOT plugged in and working, but with basic wiring knowledge you should be fine. They give you enough wire for the nav lights, all I did was run the wire down the door panel into the cab and then connect it to fuse #37 I believe (trailer control module so the nav lights come on from the headlight ), and then routed a wire from…

I really like them, but there was one big problem: to install them you also need a module for the back of the mirror (unless you want to cut and splice the wires) and the rear-facing module is not good. The connector for this module connects to the rear facing module and this connection was broken on the units sent to me. I'm not sure if the pins on the other module or the connector on this module were the culprit, but it didn't help either way. The light on this module is quite dim. Pleases…

Installed on the 2013 Ford F-150. First take your time to remove the mirror, insert the flat head between the tabs and twist starting from the bottom, the top tab should just pop off, there is a youtube video on this. I didn't remove the doorknob either, just put a stool or something similar on which the door panel could sit after removing it. To power the white light I used fuse number 40 which is responsible for the front position lights. Then the white light will turn on along with the…