🔧 Samsung Dishwasher Sensor DD82-01118A Review

Repaired my dishwasher. It flashed a faint light and stopped about 9 minutes into the cycle, which usually indicates a drain issue. But after troubleshooting and verifying that this isn't the case, I found that I was able to put the washing machine into maintenance mode. Then lights flashed indicating problems with the drain, one of which was the temperature sensor. This feeler. Finally, after a week without a dishwasher (with 3 kids), I got back to work.

I kept getting IE or SE errors. Based on search/YouTube I had to replace this part. The original part has 4 wires. The first part I received only had 3 wires. Using this part gave me EE errors (high temperature) and SE errors. So I sent the part back and asked for another one. This time I got a part with 4 wires. Exchanged and no problems! Make sure you have 4 wires. Check out other reviewers' comments on installation - easy enough. I also changed the oil seal - I don't know if that's necessary

I spent a couple of weeks with my 2 year old Samsung dishwasher which sometimes worked and sometimes gave error code 1E. After a bit of research, I found that I could fix the problem by simply replacing the sensor. After almost 3 months we had no more problems. Replacing on my Samsung DW80F800UWS is easy: - Remove the dishwasher mold under the counter - Turn over the bottom cover and remove - The sensor and connector should be clearly visible - Twist to remove the sensor and the Disconnect the…

We had an issue with our dishwasher that was flashing sensitive light and not doing full cycles (fill water, drain, fill water, drain, then stop after 9 minutes). Read some posts about possible problems. Many say that the problem lies in the sewers. All drain hoses were open and clean. Found a thread that mentioned a thermistor sensor. Ordered a different thermistor then pulled out our dishwasher and realized we needed this part. I watched videos online on how to do it (the repair clinic has…

This part fixes the Smart Auto & Normal high temperature blink error on our unit and it works again. Highly recommended if you are replacing this part you also unscrew any screens that cover the bottom in the tank of the machine and clean everything under that area... it was really horrible and caused this part to fail as it came with covered with dirt over time. We have had this machine for 8 years now and this part is a weak point in the design as is the "body brake" water level sensor on the

My Samsung DW80F600UTS/AA worked for part of the cleaning cycle then stopped and started flashing SMART AUTO and NORMAL continuously until power was turned off by turning it off became energy. block (or reset circuit breaker depending on how you set it). The error here is caused either by too hot water entering the device (+80 ° C in 3 seconds) or by a defective water temperature sensor. BEFORE YOU ORDER, MAKE SURE YOUR DEVICE HAS THIS WHITE TEMPERATURE SENSOR AND NO THERMISTOR. There are two…

With a quick search on the web I found out that this means the ECS sensor (high temperature sensor) was throwing a code which actually stalled the dishwasher. I have taken this dishwasher apart several times and had to clean this sensor because it was covered in dirt. I'm very glad I found this sensor on Revain Prime even though it was the most expensive I found on the web. After the delivery and knowing that I would receive it in 2 days, I chose Revain. I'm only giving 4 stars because it…