🔲 Tapered Diamond Reamer - SE DF83510 Review

Shank is smaller than advertised and will not fit 1/8" collets 1/8" "Collets for Micromotors. They fit into my Dremel 1/8" collet, which actually tightens less than 1/8". The length and diamond ridges are fine, only the diameter is below average.

They do not have handles as in the picture! That's a misconception, it's just advice. I'm a little sad because I have nothing to hold on to. At the same time, these are really good bits, they enlarge gem bead holes very well, but I have no grip. Where do you buy the pen that takes these attachments?

These are by far the best reamers I have ever owned. They cut my work time in HALF because they are so well made - in other words, the diamond coatings are applied with the correct adhesive and the grit is big enough that I don't have to switch to a new reamer after over a week now. They expand bead holes quickly (I've used them for both wooden and plastic beads so far). I don't have to stop every few minutes to brush off the plastic dust (it usually sticks to the reamer and makes cleaning…