🔥 Black SkyTech 1410T/LCD Timer Control (SKY-1410T-LCD-A) for Fireplace Remotes and Thermostats Review

I have a built in wall switch but I needed a remote control to turn the fireplace on and off. I wired it in parallel with the existing wiring so the switch would work in the event of a power failure. The remote's operating range is perfect for my large area (about 1000 square feet). Installation was very easy for me - took less than 5 minutes as I have good clearance under the firebox and the drive wiring is easily accessible. I've been using the remote for over a month now and it has proven to

Ideal if it worked. I connected it according to all the instructions, clicked both the receiver and the valve on my gas magazines, nothing happens, no light / valve did not open. I called the hotline and they didn't help either. returned. I reconnected my old remote and receiver and it worked flawlessly. This uses 4 AA batteries which I have tried to eliminate as around 4-5 sets of batteries are needed in the winter. I think the 110 volt receiver wasn't putting out enough power to do the job…

I bought this remote to replace the original RC-STAT Heat 'N' Glo remote for my gas fireplace which was flicking on erratically every few weeks. After some research I decided on this model because a timer would be more convenient for me than the original RC-STAT's thermostat-based control, which I never used (which is why I didn't buy the TH Skytech model). ). and of course I already had a 110v socket so I didn't have to buy one of the Skytech models with a battery powered receiver. It took me…