221376 Sliding Drawer Track Glides by Slide Co Review

I was beginning to wonder if they even had replacement rails for our dresser since it's 50 years old, but they were perfect. Many Thanks

I saved myself the trouble of sending it back and changed it. My advice: check size, check, check, because there is always confusing information that can lead to the wrong size. .

Works great! Perfect replacement for our drawers. I would recommend the small screws for attachment rather than the included nails. Pre-drill holes in wood and plastic before assembly. I removed the sprocket as I would have preferred screws and pre-drilled plastic guides.

My desk has a drawer that I opened and the entire contents fell on the floor when the original drawer slide broke. I had no idea where to find a replacement and then I remembered that if there is one, it's probably on Amazon! And here it is! I wasn't sure if the size would be right but it was very cheap and worth a try. Of course, it arrived quickly and I was able to replace it in minutes. The drawer opens and closes again with no problems. Everything should be so easy!

I bought these slides to repair a dresser drawer. When I tried to open one of the drawers it jumped almost halfway out and then tipped over and fell out of the dresser. I was looking for a cure and found these drawer slides. The dimensions corresponded to the broken splint in my chest. I purchased and installed a resin drawer slide and my dresser works like new. I am very satisfied with this product. Make sure the dimensions of the replacement drawer slides match your broken or damaged slides…

As several customers have noted this is a replica of the Ronthor Reiss rail that was likely supplied with your furniture. Above the "C" shaped groove at the bottom of this rail is an open slot to accept the rear end of a wooden rail attached to the bottom of the crate. This helps align this lead with the track. The only complaint is that the included fasteners are 3/4" long, which is probably longer than you need and may protrude through the back of your drawer. I bought some 3/8" screws from…

I have a Bassett dresser. Last year some stuff fell behind a drawer and I had to pull the drawer all the way off the rails to get to the stuff, but drawers aren't built for that. Every time I opened the drawer more than a few inches, the drawer started falling out. I searched nearby stores including major department stores like Lowe's and Home Depot but couldn't find the exact part I needed - the sizes were slightly different. It was my husband who found the role on Revain. and also . amazing…

I bought these to replace furniture that was over 40 years old and they are an exact replacement. The manual is labeled Ronthor Reiss Corp NYC, R-40-28, and PAT. NO. 3201187'. Exactly the same wording as the original instructions, in a slightly different font and shape lines. Without putting them side by side you wouldn't know they weren't taken apart by a few minutes. Each package contained one (1) white plastic drawer slide, two "L" shaped side rails, and four knobs. Issued in 1963, this…