Header banner
Revain logoHome Page
πŸ” spectre performance (spe-98625) 14-inch low profile profab inlet kit logo

πŸ” Spectre Performance (SPE-98625) 14-Inch Low Profile ProFab Inlet Kit Review

4

Β·

Very good

Revainrating 4 out of 5Β Β 
RatingΒ 
4.0
πŸ”§ Emission System, 🏎️ Performance Car Parts & Accessories

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ” Spectre Performance (SPE-98625) 14-Inch Low Profile ProFab Inlet Kit

Description of πŸ” Spectre Performance (SPE-98625) 14-Inch Low Profile ProFab Inlet Kit

14 In. x 3 In. low profile design with one 4 In. inlet welded and one 4 In. inlet ready to weld where you want it. Fabricated from high quality aluminum. Fits all carburetors and TBI throttle bodies with 5 1/8 In. inlet. Zinc plated drop base for increased hood clearance; requires a minimum 2.4 In. above the carburetor flange.

Reviews

Global ratings 4
  • 5
    2
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

1973 Triumph Stag Retro Power

Triumph Stag Retro Power Had to lower the center 2 inches to clear the hood. Looks good and has the necessary freedom of movement.

Pros
  • Filter
Cons
  • I'll Be Quiet

Revainrating 5 out of 5

1973 Triumph Stag Retro Power

Triumph Stag Retro Power. I had to lower the center 2 inches to free the hood. Looks good and has the necessary freedom of movement.

Pros
  • Made of high quality aluminum
Cons
  • Blank

Revainrating 5 out of 5

Twin Tube Air Cleaner

Very good product that requires a weld cap to adjust the angle between the two inlets. The freezer works much better than the original style and is designed to hold a cold air hose.

Pros
  • Galvanized flip-up base for increased hood clearance; at least 2.4 inches are required. via carburetor flange
Cons
  • cons

Revainrating 3 out of 5

this looks great in my

Warning to those considering this air cleaner - this is a work in progress. This means that the surface is made of raw aluminum. For me it was no problem. The product is what you would expect from a Specter - a mid priced part with decent welds and material quality. With a bit of lube and lots of polish it looks great in my engine bay. My only concern is that the steel base doesn't actually seal the air cleaner hat. While I'm sure 80% of the air enters through the cold air duct, I'm a little…

Pros
  • 14 inch engine bay. x 3 inches. Low-profile design with a 4-inch. The intake is welded and a 4V. The intake is ready to be welded in place
Cons
  • Minor issues