Tire Spoon Lever Iron Tool Motorcycle Bike Tire Change Changer Kit with Case - Set of 3 Review

Used 4 times so far. The spoons are well made. It doesn't look like the nickel plating is peeling off like the old spoons I've had for years.

I had a hard time replacing the tube in my 4.10 x 3.50 handcart tires, using screwdrivers and punching holes in the tube each time. It was easy with these little spoons and no broken tubes.

Perfect for changing tires on my dirt bike, however they could be a bit stronger. Don't get me wrong, they worked great, but I have a feeling that with years of use they will loosen and start to bend.

I gave it four stars because I have nothing to compare. This is the only time I've used something like this. I watched videos on YouTube and then ordered them. I could change a dirt bike's rear tire in about 45 minutes and swear decently.

Purchased to make changing tires on mini bikes easier. Without them, it's just an almost impossible task. They provide a lot of leverage and won't damage the bead (like a screwdriver or other inappropriate tool can do). A tip for fitting small tires (or big ones): when sliding the second bead onto the rim, use a vise clamped to the edge of the rim to keep the tire bead from unrolling (both sides), this makes the job very easy. a little soapy water or tire mounting grease in a spray can also…

So I have a No-Mar manual tire changer and recently changed tires on my ST-1300. The OEM tires are Bridgestone "Battlax" tires and they have an extremely stiff sidewall. The front worked fine but I struggled to get a second bead in the back. I've tried all the tricks - lots of grease, wooden blocks to keep the bead in the groove, a ratchet strap to keep the tire firmly on the wheel. This failed. I was ready to give up when I decided to buy these mounts. (Pay for tire fitting or take the bike to

As an on-call motorcycle tire changer, I have used many different types of tire changers over the years to remove/install tires and repair flats on everything from a '90 Honda Trail to a Harley Big Twin. . I've used 16" Motion Pro mounts (MP part number 08-0007) in the past and loved the benefits of the Motion Pro mounts, but hated the rough black oxide finish that rusted instantly and didn't slip easily . Rim/Tire Surfaces. However, these spoons are amazing in comparison! The hard chrome…