🔌 Standard Motor Products S776 Pigtail/Socket: High-quality Wiring Connection for Auto Electrical Components Review

I'm sure it works fine but it does NOT fit my Dodge Jack although Revane said it fits perfectly. Not even worth the money to send it back ugh.

The ends of the wires are quite long and the fitting has the same wire markings as the original although the wires are all the same colour. Worked like a factory.

Replaced my 02 TJ socket quick and easy. The bracket has lost its seal and damaged the socket. I used epoxy to reseal the attachment and replace the pigtail. Fast, cheap and easy.

Great indirect replacement for the front turn signal on my 1998 XJ. Simply pull out 3 pins from the new and old sockets. Then plug the 3 pins from the old one into the new socket on the cable harness. Biketi Bam is back in business

I kept changing my turn signal bulb only to find out I had to replace the socket. It was easy to fix and I didn't have to visit a mechanic which saved me a lot of time and money!

Finally fixed the side/turn signal issue I had after more than two years of "probably just a broken wire somewhere". and more than a frustrating couple of hours trying to find that free cable. Because it wasn't a free wire. The old outlet was hardly rusted enough to not work with a lightbulb, but it showed up fine on my multimeter.

If you watch the installation video on YouTube, many people take out the headlight to work on the turn signals on a 1997 Dodge Dakota. It's not mandatory. Simply remove the small rubber grommet between the grille and the headlights, remove one screw between the turn signal lenses and pull straight out. Somewhat limited space to work, but done in under 10 minutes. The item fits perfectly and arrived quickly. All is well.

This item was an exact replacement for my 1998 Dodge Dakota. Before purchasing these replacement sockets, my front right turn signals did not work at all. The back would be, but not the front. So at the time I determined that the problem was due to an outdated socket. I replaced both bushings on this side, since I was going to take them apart anyway, I figured I could just replace both at the same time. Replacing parts took no more than 10 minutes. Everything snaps in as it should, the bulbs…