Stanley 0 83 122 Corner Heavy Duty Multicolor Review

Since the tail of the lag screw rotates but does not retract (does not retract into the housing), the minimum dimensions of the box will be limited by the mating of the screw tail. Compose the box and you will see how the clamp tails met inside the box. This is where the size of the mini is limited - it seems to be about 25 cm by 25 cm, the minimum box assembled with these clamps can be made up. This cannot be called a disadvantage - this is a limitation on the size of the box that I have…

useless toy, it may come in handy just to "hold" at the time of assembly, two parts under 45 cannot be fastened together - they will not converge, only 90 degrees and then, as said above, "hold", why? because there are simply no 90 degrees and they can’t be adjusted in any way (see the photo of the inside) - big words about casting and metal are crossed out by poor plastic bushings that hold this metal on a worm and shift / bend when tightened, for the same reason, apparently the manufacturer…

I bought 4 pieces for a promotion, but after the purchase I realized that for 95% of tasks two or even one would be enough. A must have, I recommend! With its pros: Solid and high-quality clamp, you feel that you are swinging a thing. Nothing sticks or wedges, very comfortable handle. Thought out to the smallest detail: There are additional protrusions so that the workpieces hold better (although they could have been made more). Holes for mounting on a workbench, two on one part of the clamp…

Received, tried and ordered another one. For 842 norms. I thought it would be plastic and flimsy, but not soundly. Let's look further.

So far, it holds any reasonable degree of tightening of the frames. The truth is somehow suspicious. I think they will work. Good merchandise.

I bought one piece for testing, for twisting chipboard panels, pulled off the corner and drilled holes for screeds, nothing runs away anywhere, it turns out much more accurately than on the knee.

The body of the product broke after a little effort. This miracle of Chinese production was bought to fix the door frames during assembly. As a result, this is only suitable for assembling panel structures and using fixed products on both sides, because When tightening the jaws, the clamps turn out and form an incorrect angle. Some pros: There are no merit in this product. The design and workmanship do not allow calling it an angle clamp. Cons below: The quality of the material, the quality of…