🔑 2007-2015 Buick Cadillac Chevy GMC Saturn Key Fob Shell: Remote Case & Button Pad (15913415, OUC60270) Review

Perfect Factory Replacement. The woman didn't like that she had a tear. It was quick and easy to disassemble the old one and swap the circuit board for the new one. Happy wife happy life!

I don't know what transparency is, but the shell feels nice. The battery compartment is slightly larger than the original and the battery floats in place. I had to cut off the corner of the zip pouch it was in, fold it up and place it under the battery so it stays connected to the transmitter.

The back cover of the case did not keep the battery in contact firmly. I had to tape masking tape to the side of the battery to hold it in place. The metal ring bent when placed on the assembled case (bad heat treatment?} so I had to reuse the ring from the old case. I was able to get it to work but I don't recommend it.

A bag is a surprisingly rough place. route for you. Don't forget to clean the contact pads while you have it open. Wipe off some isopropyl alcohol. Gently go over the pads with a soft eraser. With the same success, you can purchase a new battery. If you have a digital voltmeter (DVM), check the voltage. and keychains. There have always been problems with intermittent response. With new shells they work constantly.

It didn't work at first when I put electronics in it. I wanted to go to work. Then I changed the rubber bands. no I think my electronics are broken now. set and it worked. So both sets work. I find the new case a bit tricky. If you don't succeed the first time, don't give up. Play around with it a bit and make sure everything is fine. pk mine eventually did.

The bag is a surprisingly rough place. If you're confident that the circuit board is ok - and you're dreading plugging a new key fob into an old car, then this is the way to go. Don't forget to clean the pads while it's open. Wipe clean with isopropyl alcohol. Gently go over the pads with a soft eraser. With the same success, you can purchase a new battery. If you have a digital voltmeter (DVM), check the voltage. and keychains. There have always been problems with intermittent response. With…

The original remote housing for my 2011 Chevy Silverado 1500 was brittle and deteriorating. I decided to try replacing the case myself before spending the money to replace a brand new remote that needs a locksmith to program it. My original circuit board fits snugly in the new case (with new rubber key membrane). The only difficulty I had was fitting the rear of the fuselage to the front half. This is a tight fit; I had to run my thumb around the edges of the back half to "snap" the halves…